Device eth0 issue. Perhaps you need to install the correct module/driver in order for it to load correctly. '3c501 device eth0 does not seem to be present'. Im unable to activate this NIC and receiving '3c501 device eth0 does not seem to be present, delaying initialization'. Download this driver, build.
Device Eth0 Is Already A Member Of A Bridge
I have swapped out four known working, different bran network cards. Each one I get the same error as in the subject. If I boot to a Live CD such as CentOs 5.3 LiveCD both Nics are given an IP. This seems to only be happening with my CentOs 5.3 server install.I noticed the CentOS Live CD the Nics were reversed from eth0 to eth1 and eth1 to eth0.
At the moment as of the output of the commands, I am running two identical Nics, since the first one has always worked. I have previously used an rtl8139, 3com c3905-TX, onboard Rhine III based (now disabled) Here are steps I have done to try and figure this out:
Quote:
[root@centos ~]# lspci | grep -i eth
00:0a.0 Ethernet controller: VIA Technologies, Inc. VT6105/VT6106S [Rhine-III] (rev 86)
00:0e.0 Ethernet controller: VIA Technologies, Inc. VT6105/VT6106S [Rhine-III] (rev 86)
Quote:
[root@centos ~]# cat /var/log/dmesg | grep -i eth
eth0: VIA Rhine III at 0xee800000, 00:1b:11:bb:17:7d, IRQ 177.
eth0: MII PHY found at address 1, status 0x786d advertising 05e1 Link 45e1.
[code]....
I went through the system-config-network-tui. I copied /etc/sysconfig/network-scripts/ifcfg-eth1 to the ifcfg-eth0 and edited for sanity. and as stated earlier, have swapped out four different nics for eth0, and booted to two different LiveCD's. Both LiveCD's work fine.